Solving the mystery of the rising cold store floor

Print

James Cunningham of Barpro Storage shares his experience where cold store floors had begun to rise because of issues with the electrical heater mats of the glycol systems. What can go wrong and how do you prevent it?

Heater mat being covered by a thin concrete layer

In a newly commissioned Danish freezer some years ago, a Storax mobile refused to move. After some initial panic, it was found that the obstacle was a ridge in the concrete floor. As the floor had been checked for level after initial curing, the newly formed ridge was surprising.

The floor had a glycol heater mat beneath the underfloor insulation and every circuit had a flow meter outside the building so that movement of the glycol mixture heated by the refrigeration system condensers could be easily checked.

A bumblebee had become lodged in a flow meter obstructing the flow of glycol and allowing ice to form in the sub-floor and creating the problematic ridge through ‘frost heave’. The bee was removed, the ice melted and the ridge disappeared without cracking the concrete floor.

In Australia, 200mm pipes are laid under freezer floors and air pumped through them to stop ice from forming in the subfloor. At one freezer the pipe did not have sufficient fall, condensation puddled and froze obstructing the pipe eventually causing the cold store floor to rise. At one local store, similar air vents were blocked to prevent rat ingress. This floor rose by 900mms.

In South Africa, while some recent stores have installed glycol systems, most rely on electrical heater mats which normally consist of three circuits of wire a little like a hot blanket on a bed. The wires lie in a sand bed which may or may not be held together with a weak cement mix. The circuits end in a control box which turns them on only if the temperature beneath the cold store floor dips beneath 4°C.

This temperature is interesting as water with impurities can freeze at higher temperatures than zero. Some chill stores have found this to their cost, as heater mats were considered unnecessary. As the business changed temperatures were dropped to -0.5°C and the rooms were kept running all year round instead of being switched off in the summer months. After several stores experienced frost heave, heater mats and underfloor insulation have now become part of the building design.

While it may sound obvious, check that the heater mats are on when the chamber is commissioned. We have seen at least three stores where the floor rose through frost heave because the heater mats had not been turned on. In one instance the floor subsided. In the others the movement had already cut the wires.

Read the full article